MUTOH Rockhopper II Series Guide de l'utilisateur télécharger pdf (Page 20)

Handling Roll Media – User’s Guide

AP-75100, Rev.2.0, 26/11/04

Step 8 : While holding down the end of the media, hold the scroller and roll out a bit of media. Remove

slack and skewness, then align the right edge of the roll media parallel with the media loading

position.

1. Scroller 2. Media loading position

Notes :

• The media loading position is a guideline for setting up the media.

• If the right edge of the roll media is 5 mm or more from the media setting position, a

media set error may result if the media is not detected. Make sure to set the right

edge of the roll media within 5 mm of the media setting position.

• If it is not possible to set the right edge of the roll media within 5 mm of the media

setting position, refer to the figure below and set the scroller position.

• If the right edge of roll media is not in line with the Media loading position, adjust

the scroller position as shown below.

When moving the roll media to the left

¾ Rotate the scroller adjustment screw counterclockwisely.

1. Scroller adjustment screw 2. Scroller

3. Roll media 4. Media loading position

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 94 95

Pas de commentaire

MUTOH Rockhopper II Series Guide de l'utilisateur Page 20