MUTOH Rockhopper II Series Spécifications télécharger pdf (Page 152)

Rockhopper II series printers – Maintenance Manual

153

AP-74065, Rev. 1.2, 27/09/04

5.5.3 Head Nozzle Check Menu

In this menu, you can check if the head nozzles, after refilling, can discharge ink correctly by printing a

sample print.

To print out head nozzle check patterns, follow the steps below. The following is the description of the

printing method.

Step 1 : Set media as necessary.

Notes :

¾ Refer to the User’s Guide.

¾ Pressing the [ENTER] key in the Diagnosis menu in self-diagnostic mode moves the

lever up and down.

Step 2 : After media has been set, the machine prints out head nozzle check patterns in the following

modes. The following is the description of the printing method.

¾ 1 pass Single way

Step 3 : Check the printed head nozzle check patterns for the following points. Check points are as

follows.

¾ Ink nozzle discharge amount (omission, discontinuity, meandering)

¾ Satellite

¾ T fence

¾ Nozzle alignment in vertical direction

¾ Nozzle alignment in horizontal direction

Nozzle check: Prints out patterns in the order of 1A, 1B, 2A, 2B, 3A, 3B, 4A, 4B.

Nozzle alignment in vertical direction: Prints out patterns in the order of 1A, 1B, 2A, 2B, 3A, 3B,

4A, 4B.

Nozzle alignment in horizontal direction (CW): Prints out patterns in the order of 1A, 1B, 2A, 2B,

3A, 3B, 4A, 4B.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 318 319

Pas de commentaire

MUTOH Rockhopper II Series Spécifications Page 152