MUTOH Rockhopper II Series Spécifications télécharger pdf (Page 252)

Rockhopper II series printers – Maintenance Manual

253

AP-74065, Rev. 1.2, 27/09/04

7.17 FLUSHING BOX HEIGHT POSITION ADJUSTMENT

Incorrect position of the flushing box height will cause large ink drops on the printout.

Please follow the steps below to correctly adjust your flushing box height position.

Before adjustment of the flushing box height position, please make sure to have:

1. The “Flush Box Height Jig Tool” (JD-80001)

2. The “Spacer kit flush box” (KY-80002).

Step 1 : Remove the I/H cover.

Step 2 : Remove side cover R.

Step 3 : Remove side cover L.

Step 4 : Remove the front cover.

Step 5 : Remove the 4 screws fixing the carriage cover.

Caution :

Please note that this cover is only on a Rockhopper II (2 heaters) and Falcon II printer.

Step 8 : Remove the carriage cover.

Step 9 : Start up in Diagnostic Mode and Unlock the Head

* Head lock *

F1 →

Lock Unlock

← F2

(1/1)

↓ Select (unlock)

* Unlock *

Wait Little time

Step 10 : Move the carriage to the left and place the flushing box height jig tool on the flushing box.

1 = Flush box height jig tool

1 2 ... 247 248 249 250 251 252 253 254 255 256 257 ... 318 319

Pas de commentaire

MUTOH Rockhopper II Series Spécifications Page 252